If you have an FTA receiver that went down due to a bad bin load or clone killer? We can jtag your receiver and bring it back to life for $25.00 (if it has a header currently installed) or $35.00 (if it doesn't have a header installed), plus return shipping.

We work on many brands of FTA Receivers, here are some of them: Ariza, Ace 2700, Coolsat, Cooltec 4000 Pro, Digisat 4000 Pro, Digiwave 6800 & 7000,  Fortec Lifetime Ultra (plus clones), Lavasat 3200, Megasat YT, Multisat, Pansat 2500A - 2700A - 3500S (plus clones), Pantec, Ultrasat, Vortex Pro and more.  There are models of these brands that don't yet have full flash dumps or that require tsop removal to repair, if that is the case we don't work on them. At the moment we don't repair, Viewsat and CaptiveWorks receivers, but will update the site once we do.

When you get your receiver back from our jtag repair service it will have the factory bin on it unless you request to have a factory bin of a different compatible receiver put on it. If you choose to have this done be sure to let us know in your service request otherwise the factory bin of your receiver will be put back on it.

Before sending your receiver remove the top cover and determine whether it has a jtag header on the board. It will look like one of the below pictures except it might just have ten pins instead of 20. Make sure your receiver is unplugged before removing the cover and also avoid touching any of the components with your hands. If you don't want to remove your cover to check let me know in your Service Request email (Read Service Request page).

Also before sending a receiver leave it plugged up and turned on whether you see any lights or not for an hour or so and feel the top of the receiver to see if it is warm or if you can hear a slight buzz sound. This is checking to see if the power supply is working, most of the time you will be able to feel the heat or hear it running. I can repair a bad power supply* but it will take additional time to acquire the power supply and additional costs. If we receive a receiver with a bad power supply we will either return it with a refund minus the return shipping costs or we will repair it after receiving the owners authorization.

It is important for you to honestly tell us what has been done to your receiver prior to paying or sending your unit to us for repair. If you have damaged your board due to over heating (soldering) or incorrectly connecting to the jtag pads we will not be responsible for the damage. There is the rare occasion that a receiver cannot be recovered by jtag'n, we have had two such cases so far (one with a bad power supply and another with damaged components), we will either refund your entire payment if you wish the receiver trashed or we will refund the payment minus return shipping cost if you want the receiver returned. We use a jig to repair boards without jtag headers, we do not solder on the boards or repair boards that someone else has caused heat damage. The reason it cost more to get a receiver fixed if it doesn't have a jtag header is it takes a considerable time to set the jig up correctly.

We usually ship the repaired stb the day after receiving it, but if this isn't possible we will let you know in our email response to your inquiry if we are unable to do so for any reason. Please check out our Payment Options page for payment instructions and our Shipping Info page shipping instructions.

Please continue to the Payment Options page. If your receiver isn't listed above or you have any questions at all please contact us at: Harps Products.

*power supply - We do not stock power supplies, so if you request a power supply the price is dependent on availability and current market.

Contact Us if your receiver isn't listed in the above satellite receivers and we will let you know whether we repair them or not.